This is a single rear poly coil spacer to help correct for vehicle lean once a vehicle has been lifted, if a lean exists. It is 10mm (0.4″) thick and is intended to be installed on top of the coil spring between the factory rubber isolator and the coil spring. This will add the same amount of lift as its thickness to help level up the vehicle. These CANNOT be stacked, only 1 can be used per coil spring.
These will suit all rear coil springs that use the factory top rubber coil spring isolator, for these vehicles:
- 4Runner – 2003 to 2019 (4th and 5th Gen)
- FJ Cruiser – all years
- Lexus GX470 and GX460 – all years
- Prado 120 and 150 – all years
This coil spacer is also ideal for vehicles with KDSS, as offset height rear coils, or a spacer on top of one side if even height coils are used, is recommended.
Remember: New Toyota vehicles come with a 1/4″ to 1/2″ lean from the factory, so anything within that range is considered “OK”.